• Industrial buildings, warehouses, supermarkets, shopping centers,
  • Light roofing for commercial constructions
  • Patio roofing, doors, screens
  • Greenhouses
Polylit
Industrial Commercial Agricultural Residential

Features:

  • UV Stabilized
  • Excellent Light Transmission
  • Lightweight
  • Rust & Corrosion Resistant
  • Highly Impact Resistant
  • Chemical Resistant

Benefits:

  • Low cost installation
  • Designed to fit most applications
  • Energy savings
  • Contributes to sustainable constructionss

Certifications:

Conforms to ASTM D-3841-97 (2008) Standard Specification for Glass Fiber Reinforced Polyester Plastic Panels.

1-1/4"

Width - 26"
Length - 24-3/8"

U - Panel

Width - 38"
Coverage - 35-5/8"


2-1/2" x 1/2" Wide

Width - 52-5/8", 51-1/2, 34", 26"
Coverage - 50-21/32", 48" 32", 24"

Wheeling Channel Drain 2000

Width - 38-3/8"
Coverage - 36"


2-1/2" x 1/2" Narrow

Width - 26"
Coverage - 24"

Wheeling 38 Channel Drain

Width - 38-1/4"
Coverage - 35-7/8"


38" Granite City Strong

Width - 38-1/8"
Coverage - 36"

Wheeling Channel Drain

Width - 38-1/4"
Coverage - 36"


KisRib

Width - 37-7/8"
Coverage - 36"

Century Drain

Width - 37-3/4"
Coverage - 35-7/8"


New Grand Rib III

Width - 37-3/4"
Coverage - 36"

Delta Rib

Width - 26-1/4"
Coverage - 24"


R - Panel

Width - 38"
Coverage - 36"

Pro IIA

Width - 38-1/4"
Coverage - 36"


Ridge Cap

Width - 24"

Flat Rolls

Width - 48"
Coverage - 50' Rolls

 
White
 
Crystal
 
Green
 
Yellow
 
Blue

Cutting

Panels can be cut using power or hand saws.
Saw blades should be fine-toothed carbide tipped or a safety fabric reinforced abrasive disc. Face shields and appropriate safety equipment should be worn by all operators. Some typical installation details are shown below.

Drilling

All panels should be pre-drilled not less than 1-1/2" from panel end, and the holes drilled a minimum of 1/16" larger than the fastener diameter. Panels can be drilled singly or several at a time.

Fasteners

When possible fastener should be installed at high points of the corrugation, with spacing of 6" to 8" on center and at end panel ends 6” to 8” on center. Fasteners should be installed 12" to 16" on center for intermediate purlins and siding applications.

Sealing

Seal end and side laps with a flexible non-hardening, UV stabilized butyl caulk.

Installation

Under no circumstances should panels be allowed to support undistributed loads such as the weight of a human body. Use only approved roof ladders for installation.